|
Steel Driveshafts | Aluminum Driveshafts | |
| Pinion Yokes | Transmission Yokes | ||
| Spec. Sheets | Guarantee Info |
Design Spec. Sheet (Page 4)
ORDER SHEET
Now that you know what you've got, let's get down to the driveshaft itself. Mostly, we need a measurement. Below are 2 ways to measure for a 1 pc. Shaft.
(1) This is the most common. Measure from; (C)Center of Rear U-Joint to; (TS) End of Transmission Output Shaft.
(2) Measure from (C);Center of Rear U-Joint to: (CS) Center of U-Joint at Slip Yoke. Use this measurement ONLY if you are going to send us your slip yoke. At DRIVELINE SHOP we believe the ONLY way to balance a driveshaft si as a COMPLETE assembly! This means the driveshaft with the slip yoke and u-joints installed.
U-JOINT SERIES OF PINION
YOKE____________________________
(NOTE: Some applications have a 4 bolt flange instead of the example given above.
Please call.)
TRANSMISSION_______________________________________
NAME______________________________
ADDRESS_______________________________________
CITY_______________________________
STATE_____________ZIP________________
CREDIT CARD____________NUMBER___________________________
EXPIRATION DATE____________
PHONE NUMBER__________________________
FAX_____________________________________
If you are mailing this, please send it to:
DRIVELINE SHOP, INC.
1842 COMMERCIAL ST.
SPRINGFIELD, MO. 65803
PHONE (417) 863-1830
TOLL FREE (800) 798-1967
FAX (417) 863-0606